2Nd Level Programming - FAAC 620 Installation Manual

Ja nu a ry , 2 00 7
6 2 0 /6 40 O pera t or A nd
6 2 4B LD C ontr ol Pa ne l Ins talla tio n M a nual

2ND LEVEL PROGRAMMING

To access 2nd LEVEL PROGRAMMING, press push-
button F and, while holding it down, press push-
button "+".
•
If you release the push-button "+", the display
shows the name of the first function.
•
If you also release the F push-button, the display
shows the value or parameter of that function,
which can be changed with the "+" and"—" keys.
•
If you press the F key again (and hold it down),
the display shows the name of the next function,
etc.
•
When you reach the last function, press the F
push-button to exit programming, and the
display resumes showing the input status.
The following table indicates the sequence of
functions accessible in 2nd LEVEL PROGRAMMING.
2ND LEVEL PROGRAMMING
DISPLAY FUNCTION
MAXIMUM TORQUE AT THRUST:
The motor works at maximum
torque (ignoring
adjustment) during the initial
time of the movement.
PRE-FLASHING:
To activate the flashing light for
5 sec before the start of the
movement
Excluded
Before every movement
Before closing
At end of pause only
SLOW CLOSING:
For setting the entire closing
stage at slow speed.
= Active
= Excluded
DECELERATION
LIMIT-SWITCHES:
For setting deceleration time (in
seconds) after the opening and
closing limit-switches have been
activated. It can be adjusted from
0 to 10 sec, in one second steps.
= deceleration excluded
= maximum deceleration
WORK TIME (time out):
We advise you to set a value from
5 to 10 seconds longer than the
required by
system to move from the closing
to the opening position and vice
versa. It can be adjusted from 0
to 59 sec in one second steps.
Next, the viewing changes in
minutes and tenths of a second
(separated by a dot) and time is
adjusted in 10 second steps, up
to the maximum value of 4.1
minutes.
P a g e 2 9
DEFAULT
the torque
= Active
= Excluded
TIME AFTER
the automated