FAAC 620 Installation Manual page 30

P a g e 3 0
2ND LEVEL PROGRAMMING continued
DISPLAY FUNCTION
FAIL SAFE:
If this function is activated, it
enables a function test of the
photocells before any automated
system movement, independently
from the output used. If the test
fails, the automated system does
not start the movement.
= Excluded
OUTPUT 1:
The output can be set to one of
the following functions:
FAILSAFE
I N D I C A T O R
(lighted at opening and
p a u s e ,
closing, and off when
a u t o m a t e d
closed)
BEAM
achieve with beam closed
and on pause, inactive
with beam open, flashing
during movement)
BEAM CLOSED
BEAM OPEN or in PAUSE,
it goes
closing pre-flashing
B E A M
OPENING,
included
B E A M
CLOSING,
included
BEAM STILL
BEAM
STATUS
LOOP 1 ENGAGED
LOOP 2 ENGAGED
OPEN FOR 624 SLAVE
CLOSE FOR 624 SLAVE
BEAM DETACHED
DEFAULT
= Active
L I G H T
fl a sh i n g at
s y s t e m
LIGHT (output
OFF during
M O V I N G A T
pre-flashing
M O V I N G A T
pre-flashing
IN EMERGENCY
6 2 4B LD C ontr ol Pa ne l Ins tal la tion M a nual
2ND LEVEL PROGRAMMING continued
DISPLAY FUNCTION
OUTPUT 1 POLARITY:
For configuring the output
polarity status.
= N.C. polarity
= N.O. polarity
NOTE: If the output is set to
FAIL-SAFE (00) leave the default
value.
OUTPUT 2:
See output 1
OUTPUT 2 POLARITY:
See Output 1 Polarity.
OUTPUT 3:
See output 1
OUTPUT 3 POLARITY:
See Output 1 Polarity.
OUTPUT 4:
See output 1, except to functions
00, 11, 12 that in this case have
no effect.
OUTPUT 4 POLARITY:
For configuring
polarity status.
ASSISTANCE REQUEST (work with
the next two functions):
If activated at the end of the
count-down (settable with the
next two functions under "Cycle
Programming"), it activates LAMP
output for 4 sec every 30 sec.
Can be useful
scheduled maintenance.
Ja nua ry , 2 00 7
6 2 0 /6 40 O pera tor An d
DEFAULT
the output
= Active
= Excluded
for setting
= Active
= Excluded