FAAC 620 Installation Manual page 31

Ja nu a ry , 2 00 7
6 2 0 /6 40 O pera t or A nd
6 2 4B LD C ontr ol Pa ne l Ins talla tio n M a nual
2ND LEVEL PROGRAMMING continued
DISPLAY FUNCTION
C Y C L E P R O G R A M M I N G
THOUSANDS:
For setting a count-down of the
system operating cycles. Settable
value from 0 to 99 (thousands of
cycles). The displayed value is
reset as the cycles progress,
interacting with the nC value (99
n c d e c r e m e n t i n g
c o r r e s p o n d
decrement).
The function
combined with nC, to check the
use of the system and to make
use of the "Assistance Request".
C Y C L E P R O G R A M M I N G
HUNDREDS OF THOUSANDS:
For setting a count-down of the
system operating cycles. Settable
value from 0 to 99 (hundreds of
thousands
displayed value is reset as the
cycles progress, interacting with
the nc value (1 decrement of nC
corresponds to 99 decrements of
nc).
The function
combined with nc to check the
use of the system and to make
use of the "Assistance Request".
NO EFFECT
NO EFFECT
AUTOMATED SYSTEM STATUS:
Exit from programming, storage
of data and return to gate status
view.
DEFAULT
I N
s t e p s
t o o n e n C
can be used
I N
of cycles). The
can be used
LED D
S ESCRIPTION
The following table shows the status of the LEDs in
relation to the status of the inputs (the normal
operating leds are in bold).
Check the status of the signaling LEDs as per table
below:
NOTE: LED on = closed contact
LED off = open contact
Operation of status signaling LEDs
LED Description
(closed contact)
DL1 OPEN Command enabled
DL2 CLOSE Command enabled
Safety devices
DL3 FSW
released
Command
DL4 STOP
disabled
Command
DL5 EMERGENCY
disabled
Opening limit
DL6 FCA
switch free
Closing limit switch
DL7 FCC
DL8 PIVOT Beam attached
A S T
UTOMATED YSTEMS
When you have finished programming, check if the
system is operating correctly.
Above all, check, if power is adequately adjusted and if
the reversing devices are operating correctly.
P a g e 3 1
ON OFF
(open contact)
Command
disabled
Command
disabled
Safety devices
engaged
Command enabled
Command enabled
Opening limit
switch engaged
Closing limit
free switch engaged
Beam detached
EST