Page 2
Salt 1 Pocket Salinity Tester Instruction Manual 1. Battery Installation Please install batteries according to the following steps. Please note polarity: “+” (anode) is upward; “-” (cathode) is downward Note: This salinity meter measures practical salinity converted from electrical conductivity (NaCl Concentration). It does not measure absolute salinity.
Page 3
3. In mode setting, short press to confirm parameter selection. Diagram - 1 3. Calibration 3.1 Rinse the probe in distilled water and dry it. Short press to turn on the tester. 3.2 Long press to enter calibration mode; Short press to exit.
Page 4
Wrong calibration solution, 1. Check if calibration solution is which exceeds the correct recognizable range of the 2. Check if probe is damaged. meter. is pushed before Wait for the smile icon to stay, measurement is stable and then short press comes up) 5.2 The tester has already been calibrated after manufacture.
Page 5
b) Restore to factory default: Select Yes to restore the calibration to the theoretical values and parameter setting to original values. When meter’s calibration or measurement performs abnormally, this function can be adopted so the meter goes back to factory default setting and then users can conduct calibration or take measurements again.
Page 6
Warranty period is the time limit to provide free service for the products purchased by customers, not the service life of the tester or probe. Oakton Instruments reserves the right to update the information in this manual without giving notice in advance.