Operation Of Free-Wheeling (N-D Lever); Seat Adjustment / Dismantle - CareCo Li-Tech Velo Instruction Manual

Table of Contents

4. INTRODUCTION & OPERATION OF SCOOTER

4.4 OPERATION OF FREE-WHEELING (N-D LEVER)

FREE-WHEELING (N-D LEVER):

» When lever is in Drive (D) position, the

scooter can be driven. Normal position

is in D (Figure 17)

» When lever is Neutral (N) position,

the scooter can be moved manually

without power (Figure 18)

» Freewheel operation is only recommended on flat surfaces. Never leave

your scooter on gradient with its motors disengaged.

» When adjusting N-D lever, do not sit on the scooter.

» It's not able to drive the scooter when the lever is in Neutral. You must turn

off the scooter first and switch to D lever, then turn on and drive scooter.

4.5 TILLER HEIGHT ADJUSTMENT

» Loosen (counterclockwise) the screw knob to adjust the

tiller height, tighten (clockwise) screw knob again to lock

at a desired position.

» There is a stop point on tiller, the height cannot exceed

the stop point (approx. 20cm) (Figure 19)

» Please refer to section 5 for scooter folding / unfolding.

» When scooter is being folding, the seat latch will

automatically release and seat will move backwards.

» After unfolding, the seat shall automatically move

forwards. However, please always double check and

push the seat to its locked position) manually if not.

» Do not get on the scooter if the seat is positioned in red

point(H).Get on the scooter only if the seat is locked in

its position green point ( Fig.20)

Figure 17

Figure 19

Figure 20

Figure 18

Table of Contents

Show Quick Links

Table of Contents