Leica GR10 Operational Manual page 109

Printed Documentation
realtime message from different reference stations are sent on the same radio channel.
Only visible when Time slicing is checked.
Nr of
reference
stations
Select the number of reference stations in use from where realtime messages are sent on
the same radio channel.
Select the time slot. This field is only visible when Time slicing is checked.
Time slot
The time slot represents the actual time delay. The number of possible time slots is the
number of reference stations in use. The time delay equals 1 s divided by the total number
of reference stations. If two reference stations are used, the time delay is 0.50 s. Therefore,
the time slots are at 0.00 s and at 0.50 s. With three reference stations, the time delay is
0.33 s. The time slots are at 0.00, 0.33 and 0.66 s.
The following settings are dependant on the selected version and message type.
Data rate
Coordin te rate a
Info rate
Message xx rate
Message xx repeat
Message 9nr. Satellites
Press to go back to the previous wizard step. Press
Press to cancel and return to
108
Select the rate at which data will be sent.
Select the rate at which coordinates will be sent.
Select the rate at which the Reference Station information, such as point ID will
be sent.
Enter the rate at which the selected messages will be sent out.
Enter the number of times the selected messages will be repeated.
The number of satellites to be included in message 9.
GNSS management: Outgoing data
to continue to the next wizard step.
stream.