Wiring The Control Panel Connector - PESA RCP-48X Manual

RCP-48X

2.6 Wiring the Control Panel Connector

Should an additional control panel be added to your system, it will be
necessary to wire the connector using shielded twisted pair cable and a 3-
pin MTA connector. See Figure 2–4.
1. Remove approximately 1 1/2" of insulating jacket from each of the two
2. Remove approximately 1/2" of wire insulation from the black and red
3. Twist together and insert the two black wire ends into positon 1.
4. Twist together and insert the two shield wires into position 2. Crimp
5. Twist together and insert the two red wire ends into position 3.
2
INSTALLATION
page 2.4
Installation
wires.
wires.
Crimp down using a screw driver.
down using a screwdriver.
Crimp down using a screwdriver.
Figure 2–4 Wiring the Control Panel Connector
Section 2