Packing Up Conquest - Sensors & Software Conquest Series Manual

Conquest
3

Packing Up Conquest

1. After scanning is complete, power down the system with the Power Off option from
the main menu.
2. Unplug the system and LCD monitor power cables from the AC power supply and
carefully place these cables into the deeper storage area behind the monitor.
3. Place the Sensor Head back into its storage location in the Conquest carry case and
place the cable into the storage area behind the monitor. Ensure that the part of the
cable closest to the Sensor Head is set into the foam channel cut-out so it is not
damaged when the monitor is lowered into its storage position.
4. Ensure that the optional Remote Receiver Cable runs inside the foam channel cut-out
so it is not damaged when the monitor is lowered into its storage position.
5. Carefully lower the LCD monitor into its storage position and close the lid of the carry
case, securing the 4 plastic latches.
6. The carry case has wheels and an extendable handle so the Conquest system can be
easily transported.
The Conquest system comes in a strong, weatherproof plastic case with wheels and an
extendable handle for easy transportation. The Conquest system can be carried like a suitcase
using the large handle on the front or pulled upright on the wheels when the extendable handle is
employed. When pulled upright, you must move the tab to pull out or push in the handle.
7
3-Packing Up Conquest