Sony PDW-1500 Operation Manual page 121

Message in time Display
data display
condition
Disc Damage off
Non AV Full off
No Clip! limit
Disc Top! limit
Disc End! limit
TC EXT! on
REGEN mode! on
REC RUN! on
REC-PAUSE! on
REC mode! limit
REC mode! limit
a) With respect to setting of basic menu item 016
During recording and editing operations
Message in time Display
data display
condition
Disc Error! off
525/60 sig! limit
625/50 sig! limit
Description
a)
A command was received to record,
display an E-E picture, record an
essence mark, or add a quick scene
selection sub clip when there was no
free sparing area.
A command was received to record,
display an E-E picture, record an
essence mark, or add a quick scene
selection sub clip when there was no
free Non-Real-Time space.
A playback or search command was
received for a disc containing no
recorded clips.
A PREV or reverse high-speed search
command was received with the disc
stopped at the top.
A NEXT or forward high-speed search
command was received with the disc
stopped at the end.
A time code or user bits preset
command was received with extended
menu item 626 "TC MODE" set to "ext
preset."
A time code or user bits preset
command was received with extended
menu item 626 "TC MODE" set to "int
regen," "ext regen," or "rp188 regen."
A time code or user bits preset
command was received with extended
menu item 627 "RUN MODE" set to "rec
run."
A time code or user bits preset
command was received with recording
paused.
A command to switch video or audio
signals was received during recording.
A command to switch audio channels
was received during recording.
Description
a)
Normal recording is not possible
because of a disc defect.
An NTSC signal was input with this unit
in 625 line mode (PAL system).
A PAL signal was input with this unit in
525(U) or 525(J) line mode (NTSC
system).
Action
This disc cannot be recorded. Exchange
the disc.
Insert a different disc with enough free
capacity.
These operations are not possible.
Try the operation again after setting
extended menu item 626 "TC MODE" to
"int preset."
See 8-3-2 "Extended Menu Operations"
(page 102) about how to make this setting.
Try the operation again after setting
extended menu item 627 "RUN MODE" to
"free run."
See 8-3-2 "Extended Menu Operations"
(page 102) about how to make this setting.
Try the operation again after stopping
recording.
Action
Use another disc.
You can check the state of a disc by
checking playback condition marks (see
page 44).
Input a PAL signal.
Input an NTSC signal.
121
9-3 Alarms