Sony PDW-1500 Operation Manual page 107

Item
LINK SPEED
DUPLEX
For details of how to make settings, see "To change
network settings" (page 109).
Item
EXTENDED MENU
SETUP BANK4
SAVE MENU DATA
LOAD MENU DATA
AUTO BANK RECALL
RESET ALL SETUP
Item
SDI2 SUPER
For details about OTHERS items other than the above,
refer to the Maintenance Manual.
NETWORK CONFIG: items relating to network settings
Setting
Set the communications speed.
AUTO, 10Mbps, 100Mbps, 1000Mbps
Set the communications method.
AUTO
Full Duplex: Full duplex
Half Duplex: Half duplex
SETUP MAINTENANCE: items relating to the setup menu
Setting
Select whether or not to display the extended menu.
DISABLE: Do not display.
ENABLE: Display.
Select the bank to be stored in menu bank 4, or reset menu bank 4.
NO OPERATION: This function is disabled.
CURRENT: Store the current menu settings in menu bank 4.
BANK1: Store the menu bank 1 settings in menu bank 4.
BANK2: Store the menu bank 2 settings in menu bank 4.
BANK3: Store the menu bank 3 settings in menu bank 4.
RESET BANK4: Reset menu bank 4.
Select whether to temporarily back up (save) setup menu settings before operations such as
software upgrades.
SET button: Back up (save) the settings.
MENU button: Return to next highest menu level without backing up.
Select whether to restore (load) setting that were backed up (saved) with the "SAVE MENU
DATA" item.
SET button: Restore (load) the settings.
MENU button: Return to the next highest menu level without restoring.
Select whether to recall settings automatically from a menu bank when the system is
powered on, and if so which menu bank to recall from.
off: Do not recall settings from a menu bank.
from BANK1: Recall settings from menu bank 1.
from BANK2: Recall settings from menu bank 2.
from BANK3: Recall settings from menu bank 3.
from BANK4: Recall settings from menu bank 4.
Reset the current menu settings to the factory settings.
SET button: Reset.
MENU button: Return to the next highest menu level without resetting.
Note
The line mode setting is also cleared. If you execute this item, reset the line mode (see page
14).
OTHERS
Setting
Select whether to output superimpose characters to the SDI OUT2 (SUPER) connector.
ON: Output.
OFF: Do not output.
107
8-4 Maintenance Menu