Thrust Washer Inspection - Mdp 20/27/35/50 - Stanley Labounty MDP Series Safety, Operation & Maintenance

THRUST WASHER INSPECTION - MDP 20/27/35/50

1. Locate flat, hard ground and place the attachment on the ground. Ensure the upper jaw is secured and will not fall
during removal.
2. Remove the front cylinder pin.
3. Remove the main pivot group, as shown in Figure 31.
eND CAP
24 | MDP Operation & Maintenance Manual
• NeVer remove any pins unless MDP
is on the ground and blocked. Serious
injury or death could result.
Remove Front Cylinder Pin
Figure 30
SHiMS
MAiN BeAriNg
MAiN SHAFT
SHiMS
MAiN BeAriNg
Remove Main Pivot Group
Figure 31
eND CAP