V-ZUG Fusion 31094 Installation Instructions Manual

Installation Instructions
Induction hob with integrated range hood
GKD46TIMASZO - Fusion
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in
the order specified.
Validity
Model designation
Fusion
Identification plate
The identification plate is located next to the connection plate.
▸
Affix the second identification plate (supplied) in an access-
ible position behind the front of the fitted cabinet beneath
the appliance.
Scope of delivery
A
B G
C
General notes
If installing into a combustible material, the guidelines and standards for low-voltage installations and fire protection
must be strictly observed.
If other firing systems are being used at the same time (e.g. wood, gas, oil or coal fired heating appliances), safe op-
eration is only possible providing a room negative pressure of 4 Pa (0.04 mbar) is not exceeded at the location of the
appliance. Risk of toxic fumes! An adequate flow of fresh air must be guaranteed e.g. via non-closable openings in
doors or windows and in combination with an air-intake/exhaust-air wall box or by other technical means.
Efficient repairs can only be guaranteed if it is possible to disconnect the complete appliance at any time without
causing any damage.
Extraction mode
The extracted air must not be fed into a chimney which is used for exhausting fumes from appliances burning gas or
other fuels. Observe the local fire regulations.
Model number
31094
D E
H F
1
1039697-R02
GKD46TIMASZO
Connection plate
Identification plate
A Hob
B Filter cassette
C 2x grease filter
D Elbow 90°, horizontal
E Elbow 90°, vertical
F Flat channel, flexible
G Offsetting end piece
H Fan motor
1039697-R02
06/09/2018
Type