Performing Several Commands In Sequence Automatically; Macro Play - Sony RM-LG112 Primary Operating Instructions Manual

To clear the memory of the
remote
Press ?/1, AV ?/1 and MASTER VOL – at the
same time. The USE MODE button flashes 3
times, then goes off.
Performing several
commands in sequence
automatically

— Macro Play

The Macro Play function lets you link several IR
codes in a sequential order as a single command.
The remote provides 2 macro lists (M1 and M2).
You can specify up to 10 IR codes for each
macro list.
Setting the sequence of IR
codes
1
Press TV ?/1 while holding down USE
MODE.
The USE MODE button lights and
"LEARN" appears in the display.
2
Move the easy scroll key to select "M1"
or "M2", then press the key to enter the
selection.
3
Press the numeric buttons to select the
macro step number.
For example, to program step 1, press 1.
You can also move the easy scroll key to
select the macro step number.
The USE MODE button blinks slowly.
4
Point the remote control code receiver
section of the remote towards the
receiver/transmitter on the remote
control to be learned.
5
Press the appropriate button on the
remote control to be learned to send
the remote button code.
Lightly pressing the button once should be
sufficient.
If learning is completed successfully, the
USE MODE button slowly flashes twice
and the remote automatically exits the
macro setting mode.
When learning is not completed
successfully, the USE MODE button
flashes 4 times in quick succession and the
procedure returns to step 5.
continued
GB
13