Performing Several Commands in Sequence Automatically
The Macro Play function lets you link several IR codes in
sequential order as a single command. The remote
provides 3 macro lists (MACRO 1, 2 and 3). You can
specify up to 10 IR commands for each macro list.
The FUNCTION screen appears.
The MACRO screen appears.
does not appear in the FUNCTION screen,
use the JOG DIAL to scroll through the list until it is
displayed, and then touch it.
• Touch SEND to operate Macro Play. The current command
is displayed in black. The finished commands are grayed
• To cancel Macro Play, touch CANCEL. When Macro Play is
not operating, touching CANCEL returns to the
SENDING: Outputting the
Done!: Outputting is
• For some models, the receiver/amplifier cannot operate the
Macro Play commands as the time between each command is
too short. In this case, set "WAIT TIME" between each
command. To set "WAIT TIME", refer to "Macro Play setting"
on page 26 and 27.
• For some makers other than Sony, there are some commands
that cannot be used in Macro Play.