Table of Contents
Advertisement
Trip Amplifier 2/209
Handling with a PC
6
Handling with a PC
The trip amplifier can be reconfigured under menu support using a PC or LAPTOP with
the enclosed disk. Every item on the MENU is supported by HELP functions which are
EN
accessible via key F1. The following section explains a simple example:
Device handling
•
•
•
•
•
•
•
•
6.1
Action 1 – Preparing the hardware
2/209
2/209
2/209
Insert a copy of the disk supplied with this manual. Remove WRITE protection.
Alternatively use hard disk.
6.2
Action 2 – Preparing the software
A: <ENTER>
START <ENTER>
<ALT><C>
1
6.3
Action 3 – Preparing a back-up copy
<ALT><L>
<ALT><W>
NAME.209
40
Action 1 – preparing the hardware
Action 2 – preparing the software
Action 3 – preparing a back-up copy
Action 4 – how to edit standard programs
Action 5 – how to save and send programs
Action 6 – how to check edited programs
Action 7 – how to EDIT a program
Action 8 – ending a job
Device to be connected to 24 V DC power supply.
Device to be connected to a PC via an RS 232 link.
Set jumper MODE to 4–5 (programming mode, trip monitor
disabled).
Select drive A, A> displayed on screen.
Start program in English, the main MENU will appear on the
screen.
Select PC communications link.
Enter figure 1 or 2, select COM1 or COM 2.
Load data from the trip amplifier.
Save data in a file
This is to produce a back-up copy of the factory or original
setting.
Enter NAME and save with <ENTER>. If you want to save
data from several devices, repeat above action from
<ALT><L> and issue a file name per device (TAG No).
Advertisement
Table of Contents
