Lifting The Sewing Cage; Regulating The Sewing Cage Pressure - DURKOPP ADLER 577 Series Manual

4.5

Lifting the sewing cage

4.6

Regulating the sewing cage pressure

The sewing cage 2 will be lifted only if the main switch is turned on
and if following conditions exist:
–
Sewing cage in initial position (rear position)
–
Thread take-up lever in top dead-center position (needle in upper
position)
If the thread take-up lever does not stand in its top dead-center
position (error message in the display of the control panel: "_001 0"),
the machine will automatically turn into this position after turning on
the main switch.
After turning on the main switch, following message will be presented
on the display of the control panel: "_0001". if the sewing cage does
not stand in its initial position Turn then the crank until the sewing
cage stands in the proper position and can be lifted. By treading the
pedal forwards into its 1
without starting the sewing process.
The sewing cage can be lifted and lowered by the key 3 on the control
panel. Then it is necessary to switch on the parameter "F - 020" on
the operator level (see chapter 4.9).
3
2
–
The sewing cage pressure can be regulated by the screw 3.
st
position, the sewing cage will be lowered
1
11