Troubleshooting - Toto Washlet SG Instruction Manual

What to Do?
If the toilet is in a location you will not visit for a long time, drain the water.
(The water in the tank may become contaminated and cause skin irritation or other problems.)
How to drain the water
Close the shutoff valve.
(Page 55)
1
Drain the pipe.
2
2
(Step (1) to (4) on Page 53)
Pull out the water
3
drain lever.
• The water comes out from
near the wand for about
20 seconds.
Release your hand
4
to return the water
drain lever to its
original position.
If water may get frozen
■
•
Add antifreeze solution in the water in the bowl to prevent
freezing.
(The antifreeze solution should not be fl ushed out. Collect
it before using the toilet and dispose of it.)
■ To use the Washlet again
• The water needs to be resupplied.(See right)
54
Long Periods of Disuse
Resupplying the Water
(After draining)
Open the shutoff valve.
1
Check that water is not leaking from a
pipe or the main unit.
If the power is not turned ON
2
Insert the power plug.
(Page 15)
Switch the breaker on the
distribution board to ON.
(Concealed power connection type)
Discharge water from the
3
wand.
(1) Pressing down the left side of the
toilet seat,
(2) Press the [REAR] on the remote control
to discharge water from the wand.
(Catch the water in a paper cup or
other receptacle)
■ If the remaining water has
frozen and no water comes out
• Heat the inside of the bathroom, and
warm the water supply hose and shutoff
valve using a cloth soaked in warm water.

Troubleshooting

First, try the actions described on pages 55 to 60. If the
problem persists, consult the installer, seller or the contact
listed on the back cover of this manual.
● The CLEAN indicator does not light up
(It is time for parts replacement.➝Page 60)
Please check fi rst
Does the LED light up
■
when you press [POWER
ON/OFF] on the main unit?
Is the POWER LED lit?
■ Is the breaker on the
distribution board turned
on?
➞ Check whether there is a power
outage or the breaker has turned
"OFF".
While the LED is lit, energy saver
■
Is the
so the toilet seat temperature may be reduced or the
ENERGY SAVER LED
heater may be turned off.
lit?
■ Are the remote control
batteries dead?
Is the
➞ Replace the batteries. (Page 52)
remote control
■ Is the remote control
working?
transmitter or the remote
control receiver blocked?
➞ Remove obstructions, dirt, water
droplets or any other blockages.
Remote control
transmitter
CAUTION
If a water leak occurs, close the shutoff
valve.
POWER LED
POWER ON/OFF
is in operation,
(Page 26)
The remote
control uses
batteries
to
operate.
Close
Open
Battery cover
Remote control
receiver
55