Opening and closing
[SEAT OPEN / CLOSE]
Stopping
[STOP]
Cleansing
[SOFT REAR]
*
[REAR]
* The mode changes between [SOFT REAR] (Flickering) and [REAR] (Lit)
each time the button is pressed.
[FRONT]
*
[WIDE FRONT]
* The mode changes between [FRONT] (Flickering) and [WIDE FRONT] (Lit)
each time the button is pressed.
Drying
[DRYER]
[PERSONAL SETTING LOCK 1]
[PERSONAL SETTING LOCK 2]
You can store your preferred wand position, water pressure and water temperature
settings.
To store a setting
While cleansing is in progress, set your preferred wand position, water pressure and
water temperature, and then press and hold "
To use
After "
" or "
" is pressed, please push the button used for cleaning.
1
2
*The wand position and water pressure LED's will light up for about 10 seconds
displaying the programed personal settings. Then the water temperature display
will also show the programmed personal setting.
Basic Operations
Opens and closes the toilet seat.
(S350e, TCF4732A, TCF4731A only)
Stops the operation.
Cleanses your rear with mild water
pressure.
Cleanses your rear.
Serves as a bidet for women.
Serves as a bidet over a wider area.
Dries your front and/or rear.
" or "
" for 2 seconds or longer.
1
2
Functions that operate when a button is pressed during
"REAR", "SOFT REAR", "FRONT" or "WIDE FRONT" cleansing.
[OSCILLATING]
The wand moves back and forth to wash
your rear thoroughly. The setting
changes between "ON" and "OFF" each
time the button is pressed. You can use
this function whenever you feel like it.
[POSITION]
The wand position can be adjusted to the
front or rear.
("▲" : Moves to the front, "▼" : Moves to
the rear)
[PULSATING]
Washes with the water pressure pulsat-
ing between soft and strong. The setting
changes between "ON" and "OFF" each
time the button is pressed. You can use
this function whenever you feel like it.
[PRESSURE]
The water pressure strength can be
adjusted for cleansing functions such as
REAR.
("+" : Stronger, "–" : Softer)
If you cannot operate with the remote control
Operation is also possible using
the buttons on
the Washlet control panel.
This button cannot be used.
Washlet control panel
Need help?
Do you have a question about the washlet and is the answer not in the manual?
Questions and answers
not enough water filling the bowl after a flush
There may not be enough water filling the bowl after a flush in a Toto Washlet due to a clogged vent pipe or incorrect toilet settings. If the vent pipe is blocked, it can create a vacuum that prevents proper drainage and refilling. Alternatively, if the water level in the tank is set too low or the flapper chain is too tight or loose, it can cause a weak flush and insufficient bowl refill.
This answer is automatically generated