Gap Between The Main Unit And The Toilet Lid; Wand; Deodorizing Fi Lter - Toto Washlet SG Instruction Manual

Maintenance

Gap between the main unit and the toilet lid

The toilet lid can be removed for thorough
cleaning.
Unplug the power plug.
1
(Page 15)
Switch the breaker on the
distribution board to OFF.
(Concealed power connection type)
Remove the toilet lid.
2
: Pull the left side outward.
: Disconnect the hinge from the pin and pull up.
: Disconnect the right side.
Wipe with a soft cloth that
3
has been soaked in water
and wrung-out thoroughly.
Reinstall the toilet lid.
4
: Join the pin and the hinge on the right side.
: While pulling out the left side,
: Mount by joining the hinge with the pin.
* Be careful not to pinch your fi ngers.
Insert the power plug.
5
Switch the breaker on the
distribution board to ON.
(Concealed power connection type)
Open and close the toilet lid
6
to check the reinstallation.
32
Gap between the main unit and the toilet lid
(Perform monthly)
Soft cloth soaked in water Toilet paper, etc.
(May cause damage.)
Removing and Reinstalling
Hold with
both hands
C
B
A
D
Pin
E
(Page 15)
Pin
Hinge

Wand

Deodorizing fi lter
Wand
(Perform monthly)
<Wand cleaning> If you notice dirt
Soft cloth
Extend the wand.
1
• Operate with the buttons on the back
side of the remote control.
(1) Press [MENU].
(2) Use
Press [ENTER].
(3) Use
CLEANING MODE ON/OFF].
Press [ENTER].
• The wand extends and water sprays
out for cleaning.
• The wand automatically retracts after
about 5 minutes.
Wipe with a soft, wet cloth.
2
• Do not pull, push or press the wand
with excessive force.
(May cause damage or malfunction.)
Press [STOP] on the front
3
Hinge
side of the remote control.
• The wand retracts.
Deodorizing fi lter
<If you notice odors>
Unplug the power plug.
1
Switch the breaker on the
distribution board to OFF.
(Concealed power connection type)
Remove the deodorizing fi lter.
2
• Hold the knob and pull outward.
Toilet paper, etc.
•
Do not pull with undue force. (May cause
(May cause damage.)
damage or malfunctions)
to select [CLEANING].
Clean with a tool such as a
3
toothbrush.
• When washing with water, dry off all
to select [WAND water before mounting.
Mount the deodorizing fi lter.
4
•
Push fi rmly until a click sound is heard.
Insert the power plug.
5
Switch the breaker on the
distribution board to ON.
(Concealed power connection type)
Wand
(Perform monthly)
(Page 15)
Knob
Deodorizing Filter
Toothbrush
(Page 15)
Deodorizing Filter
33