Water Fi Lter Drain Valve - Toto Washlet SG Instruction Manual

Maintenance
Descaling mode
<When [POWER] LED (orange) and [ENERGY SAVER] LED (orange) fl ash> (Continued)
9 Remove the funnel and put cap and cover back on.
Cover
Funnel
10 Perform descaling. (2nd time)
Press [ENTER].
Descaling will be performed
( for about 60 minutes)
• Water will be sprayed from around the
wand and mist nozzle at about 20-minute
intervals
After about 60 minutes, descaling agent
will be drained to the toilet
After draining, you will hear a long beep
sound, and the LEDs on product main
body stop fl ashing
<Descaling complete>
Attention!
● If the spray is still weak afte performing Descaling mode
● If the symptom does not improve after conducting
the [POWER] (orange) and [ENERGY SAVER] (orange) LEDs start to fl ash, please perform
38
Descaling mode
<If you think the water pressure has weakened>
Attention!
● Please wipe off any spilt agent with soft
wetted cloth
(Failure to do so may cause discoloration)
Cap
DESCALING MODE 1/1
FILL IN THE
DESCALING AGENT (2/2)
PUSH[ENTER]
DESCALING MODE
DESCALING IN
PROGRESS
PLEASE
WAIT FOR
60 MINUTES
Returns to default display in about 30 seconds.
please clean Water fi lter drain valve .
Descaling mode and cleaing Water fi lter drain valve
Descaling mode
Water fi lter drain valve
Water fi lter drain valve
Close the shutoff valve.
1
•
The water supply stops.
CAUTION
Do not remove the water fi lter drain
valve while the shutoff valve is open.
(Otherwise, water may leak out)
Extend the wand.
2
• Operate with the buttons on the back side
of the remote control.
(1) Press [MENU].
(2)
Use
Press [ENTER].
Use
(3)
CLEANING MODE ON/OFF].
Press [ENTER] to extend the
wand.
Press [ENTER] again to retract
the wand.
(Release the pressure from the
water supply pipe.)
Unplug the power plug.
3
(Page 15)
or if
Switch the breaker on the
again.
distribution board to OFF.
(Concealed power connection type)
(Perform once every 6 months)
<If you think the water pressure has weakened>
Remove the cover and water
4
fi lter drain valve.
• Loosen with a fl at-head screwdriver and
then pull.
Cover
Clean with a tool such as a
5
toothbrush.
•
Also, remove any dust from inside the hole
of the water fi lter drain valve.
Reinstall the water fi lter drain
to select [CLEANING].
6
valve and cover.
• Insert the water fi lter drain valve and tighten
it securely with a fl at-head screwdriver.
to select [WAND
Cover
Insert the power plug.
7
Switch the breaker on the
distribution board to ON.
(Concealed power connection type)
Open the shutoff valve.
8
(Page 15)
Water filter
drain valve
(Page 15)
39 39