Installing A Front Low-Profile Expansion Card - Supermicro SCF424 Series User Manual

Installing a Front Low-Profile Expansion Card

Each motherboard node supports one low-profile expansion card.
Installing a Front Expansion Card into a Node
1. Power down the system and remove the power cord from the rear of the
power supply as described in Section 5-2. Remove the node from the chas-
sis as described in Section 5-3 and place the node on a flat, stable surface.
Remove the cover from the node as described in Section 5-5.
Figure 5-19: Removing the Screw Securing the PCIE Slot Cover
2. Remove the mounting screw which secures the PCIE slot cover in the PCIE
slot and set this aside for later use.
3. Remove the PCIE slot cover by sliding it upward and out of the PCIE slot.
Figure 5-20: Removing the Riser Card Bracket from the Node
Chapter 5: Chassis Setup and Maintenance
1
5
5-21
1
2