14. Remove the canopy cover from the bottom of the
canopy (Fig. 14).
Helpful Hint: Closemount mounting is more suitable
for ceilings lower than 8 ft. (2,44 m) high. The
downrod, hanging ball, and canopy cover are not
used in this type of installation.
15. Align the canopy with the closemount screw
holes in the top of the motor assembly. Secure
the canopy to the top of the motor assembly by
installing three closemount screws and spring
washers into the top of the motor housing (Fig. 15).
Closemount Screw
16. Raise the fan and place the canopy on the
mounting bracket hook for wiring. Insert the
receiver into the mounting bracket with the flat side
facing the ceiling (Fig. 16).
CLOSEMOUNT INSTRUCTIONS
Spring Washer
Fig. 14
Fig. 15
Fig. 16
10
Canopy
Cover
Closemount
Screws
Spring
Washer
Ceiling
Canopy
Receiver
Canopy
Hook