Honeywell CARMEL 50196 Manual page 15

24. Connect the two 4-pin connectors and two 9-pin
connectors from the switch housing. Insert the
connectors into the switch housing. Then, install
the switch housing cover to the switch housing
using the switch housing cover screws that were
previously removed (Fig. 24).
Switch Housing
Cover Screw
25. Install bulbs (Fig. 25).
Important: When replacing the bulb, allow bulb and
light kit to cool before touching.
26. Lift the glass globe up to the light kit and twist tightly
in a clockwise direction until it is secure (Fig. 26).
LIGHT KIT INSTALLATION
15
Fig. 24
Switch Housing
Cover Screw
Fig. 25
Bulb
Fig. 26
Glass Globe
Switch
Housing
Cover