Blade Installation - Honeywell CARMEL 50196 Manual

20. Partially insert three blade screws along with three
blade washers through one blade and into one
blade arm. Tighten each blade screw with a Phillips
screwdriver, starting with the one in the middle.
Repeat this step for the remaining blades and
blade arms (Fig. 20).
Blade Screw Washer
20. Insert blade arm through slots in the side of the
motor assembly. Align the holes of one blade arm
with two motor screw holes in underside of the motor
assembly. Secure with two motor screws. Repeat
this step for the remaining blade arms (Fig. 20).
Motor Screw

BLADE INSTALLATION

13
Fig. 19
Blade Screw
Washer
Blade
Fig. 20
Motor Screw
Blade Arm
Blade Arm
Blade