Wiring Between Control Box And Tof Sensor - Optex Accurance-3D A3001CB Instruction Manual



Wiring between Control Box and TOF Sensor

Connect Control Box and TOF Sensor with Ethernet Cable (not provided) and Sensor Power Cable
(provided)
Fig 2-21
Fig 2-22
Fig 2-23
1 Prepare Sensor Power Cable and Ethernet
Cable.
*Please set ferrite to the both end of the
Ethernet Cable.
2 Insert both cables to back of the TOF Sensor as
shown in Fig 2-22.
Insert the connectors all the way until the lock is
in place.
To remove connectors, pull out cables while
pressing the locks.
3 Insert both cables to the Control Box as shown
in Fig 2-23.
Insert the connectors all the way until the lock is
in place.
To remove connectors, pull out cables while
pressing the locks.
*When use one unit of TOF Sensor, please
connect to LAN1 (left side)
*When use two units of TOF Sensors, please
see PC Setting.
23