Once the UPS runs normally, switch on the output protective device (see
4
Figure 7-3) installed between the UPS and the loads.
NOTE :
To prevent the UPS from activating the overload protection mechanism
during start-up process, please turn on the high-power loads first and
then low-power loads.
8.2 Single Unit Turn-off
Make sure all of the loads connected to the UPS are off.
1
(1) Press and hold the ON/ OFF button (
2
you hear one beep, (3) use the Scrolling UP or Down button (
lect ' Yes ' , and (4) press the Enter button (
Amplon RT Series
Press and hold the button
for 3 seconds and release it
after you hear one beep.
Self Diagnosis
In Progress...
BATTERY
Runtime
168
min
100
%
Input
0.0V
Output
230.0V
3 8
1
75%
0.0Hz
50.0Hz
) for 3 seconds, (2) release it after
) to confirm your selection.
/
) to se-