Minimum Mounting Clearances - Honeywell CORE Drive Quick Start Manual

MINIMUM MOUNTING CLEARANCES

(Appearances shown in the following figures are only for reference)
(BLUE ARROW) INFLOW
(FRAME A-E)
SINGLE DRIVE: INDEPENDENT INSTALLATION
A A
B
INVERTER
A
A
FRAME A, B, C
MULTIPLE DRIVES: INDEPENDENT
INSTALLATION IN HORIZONTAL
FRAME D, E
MULTIPLE DRIVES: INDEPENDENT
INSTALLATION IN HORIZONTAL
INSTALL A BARRIER BETWEEN THE
DRIVES
FRAME A, B, C
MULTIPLE DRIVES: INDEPENDENT
INSTALLATION
TA: FRAME A~E
IT IS SUGGESTED TO INSTALL A
BARRIER BETWEEN THE DRIVES.
ADJUST THE SIZE OF THE BARRIER TILL
THE TEMPERATURE OF THE FAN ON THE
INFLOW SIDE IS LOWER THAN THE
OPERATION TEMPERATURE.
(REFER TO THE RIGHT FIGURE)
OPERATION TEMPERATURE IS THE
TEMPERATURE MEASURED 50MM AWAY
FROM THE INFLOW SIDE OF THE FAN.
A
B
B
INVERTER
A
(FRAME A-C)
PARALLEL MOUNTING IN HORIZONTAL
A
A
B
B
INVERTER
A A
A
B
INVERTER
A
A
B
INVERTER
A
NOTE:
THE MOUNTING CLEARANCES SHOWN IN THE LEFT FIGURE ARE NOT FOR INSTALLING THE DRIVE IN A
CONFINED SPACE (SUCH AS CABINET OR ELECTRIC BOX). WHEN INSTALLING IN A CONFINED SPACE,
BESIDES THESE SAME MINIMUM MOUNTING CLEARANCES, IT NEEDS TO HAVE THE VENTILATION
EQUIPMENT OR AIR ONDITIONER TO KEEP THE SURROUNDING TEMPERATURE LOWER THAN THE
OPERATION TEMPERATURE.
THE FOLLOWING TABLE SHOWS HEAT DISSIPATION AND THE REQUIRED AIR VOLUME WHEN INSTALLING
A SINGLE DRIVE IN A CONFINED SPACE. WHEN INSTALLING MULTIPLE DRIVES, THE REQUIRED AIR
VOLUME SHALL BE MULTIPLIED BY THE NUMBER OF DRIVES.
REFER TO THE CHART (AIR FLOW RATE FOR COOLING) FOR VENTILATION EQUIPMENT DESIGN AND
SELECTION.
REFER TO THE CHART (POWER DISSIPATION) FOR AIR CONDITIONER DESIGN AND SELECTION.
IT IS THE MINIMUM DISTANCE REQUIRED FOR FRAME A~D. IF DRIVES ARE INSTALLED CLOSER THAN
THE MINIMUM MOUNTING CLEARANCE, THE FAN MAY NOT FUNCTION PROPERLY.
Fig. 1. Minimum Mounting Clearances.
(RED ARROW) OUTFLOW
A
A
C
B
INVERTER
A
A
A
B
2B
INVERTER
A
A
B
B
B
INVERTER
A
A
B
C
INVERTER INVERTER
50 mm
A
Ta Ta
A
B
C
INVERTER INVERTER
50 mm
A
Ta
Ta
MINIMUM MOUNTING CLEARANCE
FRAME A (mm/in) B (mm/in) C (mm/in) D (mm/in)
A~C 60/1.2
30/0.6
D~F 100/3.3
50/1.7
7
HONEYWELL CORE DRIVE
A
D
INVERTER
A
A
A
D
INVERTER
A
A
A
A
D
INVERTER
A A
Ta*
D
B
INVERTER
50 mm
Ta*
B D
INVERTER
50 mm
0
10/0.2
- 0
A
A
A
A
M31500
62-0410—04