Aardvark And Eeprog.exe; Installing Aardvark - Panasonic eUniStone Application Note Design Manual


Step Command/response
 +RDOICNF
6 MAKE A HW RESET
 ROK
 AT+JPRO=1
7
 OK

8
+JCBD=083C0E19030000008A0080BA8C01BF02067E98
1F598740FA1218800003040506440C10020400011024
04F2F8FE04B90006000000000000000000
 OK
 AT+JRES
9
 ROK
10.4

Aardvark and eeprog.exe

Aardvark is an I2C/SPI host adapter from Total Phase. Aardvark can be used to update or restore
software in the EEPROM of PBA31309. Eeprog.exe and the Aardvark drivers are available on the
development CD. Eeprog.exe is special DOS software made for downloading and reading EEPROM
data. More information about Aardvark can be found here:
http://www.totalphase.com/products/aardvark_i2cspi/
10.4.1

Installing Aardvark

Connect Aardvark to the USB port of the computer.
When the driver installation started choose to install the driver manually. The driver is found on the
development CD.
Application Note
Design Guide
Description
The module shall indicate with an event that the software/patch has
been successfully downloaded
To enable the new software a hardware reset is needed
The module has now restarted and runs the new software, but with
default Bluetooth address (0003199E8B71) and default oscillator
trim value (0218).
Enable production mode
The modules shall response with OK
Write BD-data with the address and oscillator trim value read out in
step 2.
The modules should response with OK
Send software Reset to the module to make it use the written BD-
data.
Make sure the module respond with ROK.
71
PAN1322
Revision 1.2, 2013-12-18