Table of Contents
Advertisement
9
Test and Development Tools
This chapter is aimed to clarify some common issues from the customers.
9.1
Tools available for development and testing
9.1.1
SPP Toolbox
The SPP Toolbox is used to control eUniStone with AT commands, to setup links and as described in
later chapter, to do RF tests. A detailed manual is delivered with the Toolbox.
For testing of the PBA31309 with SPP AT SW 3.x the SPP Toolbox shall have version number 3.02 or
later.
9.1.2
SPP Test Tool
The SPP Test Tool is used for throughput tests, both in command mode and stream. For more details
about this tool, please see the manual delivered with the tool.
For testing of the PBA31309 with SPP AT SW 3.x the SPP Test Tool shall have version number 2.1.1.0 or
later.
9.1.3
HCI Lite
HCI Lite is used together with eUniStone when it has been loaded with Host Controller Interface
software (HCI_TL_ROM_115kbaud.eep). The purpose of the tool is to use it for advanced RF tests. A
range of HCI commands is implemented in the tool to be able to set-up eUniStone in different RF
modes.
For testing of the PBA31309 with SPP AT SW 3.x the HCI Lite should have version number 3.03 or later.
Attention: After loading Host Controller Interface software (HCI_TL_ROM_115kbaud.eep), the
device can only revert to the original SW by the use of an I2C programmer!
9.1.4
eeprog – Aardvark
The eeprog.exe software is used together with the Aardvark I2C/SPI Host Adapter to download
software to eUniStone through the I2C interface.
The Aardvark I2C/SPI Host Adapter is a hardware dongle available through Total Phase. The eeprog.exe
is only available in one version and is not dependent on SPP AT SW version.
Application Note
Design Guide
51
PAN1322
Revision 1.2, 2013-12-18
Advertisement
Table of Contents
