Safety Regulation - Talyn Plus 2 Installation & Operation Manual

Failure to observe these instructions can damage the
machine and compromise the operator's safety.
Remove the original packing materials after positioning
them as indicated on the packaging.
All regulations in force concerning safety at work must
be complied with when choosing the installation
position.
In particular, the machine must only be installed and
operated in protected environments where there is no
risk of exposure to dripping.
IMPORTANT: for the correct and safe operation of the
machine, the lighting level in the place of use should be
at least 300 lux.
Environmental operating conditions must comply with
the following requirements:
- Relative humidity ranging from 30% to 80% (without
condensation);
- Temperatures ranging from 0° to +50°C.
The floor must be strong enough to support a load
equal to the weight of the equipment plus the maximum
load allowed.
The machine must not be operated in potentially
explosive atmospheres.
SAFETY REGULATIONS
Failure to comply with the instructions and danger
warnings can cause serious injuries to the operator or
other persons.
Do not operate the machine until you have read and
understood all the danger/warning notices in this
manual.
The correct use of this machine requires a qualified and
authorized operator. This operator must be able to
understand the manufacturer's written instructions, be
suitably trained and be familiar with the safety
procedures and regulations. Operators are forbidden to
use the machine under the influence of alcohol or drugs
that could affect his/her physical and mental capacity.
The following conditions are essential:
- read and understand the information and instructions
described in this manual;
- have a thorough knowledge of the features and
characteristics of the machine;
- keep unauthorized persons well clear of the working
area;
- make sure that the machine has been installed in
compliance with all relevant standards and regulations
in force;
- make sure that all machine operators are suitably
trained, that they are capable of using the machine
correctly and safely and that they are adequately
supervised during work;
- do not touch power lines or the inside of electric
motors or any other electrical equipment before making
sure that they have been powered off;
- read this booklet carefully and learn how to use the
machine correctly and safely;
- Always keep this user manual in a place where it can
be readily consulted and do not fail to refer to it.
Do not remove or deface the DANGER, CAUTION,
WARNING or INSTRUCTION decals. Replace any
missing or illegible decals. If any decals have become
detached or damaged, it is possible to obtain them from
your nearest reseller.
-Observe the unified industrial accident prevention
regulations relating to high voltages and rotating
machinery whenever the machine is in use or being
2