Customer Self-Calibration - Talyn Plus 2 Installation & Operation Manual

SET UP
1 " "— " " Press
special function setup program
IN TES
2 option:" "– " "和 "
Select to display in cycle.
IN
In the condition of "
enter the condition of test.
In the condition of POS, rotate the tire clockwise,
the value in the right window will increase.
Counterclockwise, decrease.
Press key to test static sensor
In the condition of STA, press the pizeo sensor
perpendicular to the main shaft, the value in the
right window will change which means the
to enter the
CAL CAL
" –" "
TES
"—" ",press
installation of the sensor is correct
Press
key to test static sensor
In the condition of DYN, press the pizeo sensor

9.3 CUSTOMER SELF-CALIBRATION

In the condition of
CAL CAL
enter –
self-calibration state. We use this when the
machine has not been used for a long time or the
balancing is inaccurate.
Press to enter into the program.
to
This function can be used after inputting tire
parameter.
*hold on pressing
enter this state.
Press to enter and the display will display
ADD O
" "-" "
20
，select
IN TES
-
，means customer
for 5seconds to
to