Value Input - Talyn Plus 2 Installation & Operation Manual

6.3.2 MOUNT WHEEL
Preparation before test：Check and clean the dust and
mud and if there are foreign bodies, such as metal and
stone, clipped on the surface of the tire. And also check
the air pressure of the tire is according with the
specified value. Check if there are deformation on the
rim positioning surface and installation hole.
Check if there are any foreign bodies in the tire. Take
off the original weight.
The installation methods of the wheel ： Positive
positioning, negative positioning & flange disk when
handling the middle and big sizes of tires. You can
select the methods
conditions.
6.3.2.1
SMALL CAR WHEEL POSITIVE POSITION
Positive positioning is the normal method. It is featured
with simple and quick operation. It is mainly suitable to
the common steel rim and aluminum alloy rim with
small deformation.
Main shaft wheel（direction of the rim installation
surface is inside）
6.3.2.2
When the deformation of the outside of the wheel,
adopt this method to positioning to grantee the
accurate positioning of the steel rim inner hole and
main shaft. It is suitable to the steel rim, especially the
thick ALU
according to the
cone quick nut
Main shaft
wheel
6.3.2.3 FLANGE DISK POSITIONING （OPTIONAL）
different
Suitable to the big tire assemble
Main shaft
wheel
NOTE:
to the rim center hole and pay attention to its direction.
Or it will cause the inaccurate measurement.
6.4 INPUT VALUE
6.4.1 Input DIS（Distance）
Pull the scale to the inner position to add the weight
and press the key
value into the display. At this moment, the display will
9
lower spring
bowl quick nut
flange disk（fixed on the main shaft）
cone quick nut
The choice on the cone should be adapted
suitable cone
to input the DI