Operation Detailed Description; How To Balance A Wheel - Talyn Plus 2 Installation & Operation Manual

Consult the following table to choose the most
suitable fire extinguisher.
Dry materials
Water YES
Foam YES
Powder YES*
CO2 YES*
YES* Use only if more appropriate extinguishers
are not at hand or when the fire is small.
Flammable liquids
Water NO
Foam YES
Powder YES
CO2 YES
Electrical equipment
Water NO
Foam NO
Powder YES
CO2 YES
Warning
This table contains general instructions to be
used as guidelines for users. All the applications
of each type of extinguisher must be obtained
from the relevant manufacturer.
9.DETAILEDMACHINE
OPERATION：
9.1 How to balance a tire?
1. Switch on the power source
2. Select the cone according to the tire. Assemble
the tire on the main shaft of the wheel balancer
and firmly lock it.
3. Input the tire parameter.
3.1 Pull out the scale of the balancer to measure
the Di value which means the distance from the
insider of the tire to the body. According to
measured reading, the unit of which is cm, press
to adjust the value to make the value
displayed in the right-side window to be the
measured value. But the unit of this displayed
value is mm. eg you should input 55mm if the
measured value is 5.5cm.
3.2 Use the width measurement scale to measure
the Bre。you can press
value which is the implied value with the unit of
inch. If you want to convert this value into the
value with the unit of mm, press
realize the conversion between the units.
3.3 Check the D value, which means the diameter
of the rim, marked on the tire. Press
key to adjust the value in the right
window to be the diameter of the rim. You
can also realize the conversion of the unit of the
Dia to be mm by the
4. Lower down the protective cover（you can also
press the start key）. After the machine start,
rotate and test, it will automatic stops. In the left
/right window, the corresponding values will be
displayed. Rotate the tire, when all the position
18
to input the Br
to
key.