Residual Unbalance Value Display - Talyn Plus 2 Installation & Operation Manual

display[DIS]：[XXX]，And the default system is mm.
6.4.2 Input Br (RIM Breadth) Value
Use the Br measurement caliper to measure the Br of
the rim, press the key
value into the display. At this moment, the display will
display [Br. ]：[XXX]. and the default system is inch.
6.4.3 Input the DiA(Diameter)Tire Diameter Value
After confirming the rim diameter, press the key
to input the rim diameter into the display.
At this moment, the display will display [Dia ]：[XXX].
and the default system is mm.
6.4.4 UNIT CONVERSION：
①The unit conversion of the Br of the rim from inch to
mm:
Normally, the display of Br should be in inch. When you
need the unit of the display to be mm, you can use the
key to realize the unit conversion from inch to
mm.
②The unit conversion of the DIA of the rim from inch to
mm:
Normally, the display of D should be in inch. When you
need the unit of the display to be mm, you can use the
key to realize the unit conversion from inch to
mm.
After unit conversion, the unit of the display values of
rim Br and D value, but when you switch off and then on
the wheel balancer, the unit will be still inch.
③The unit conversion from gram to ounce：
Normally, the unit of the unbalance value is gram (g). If
you want to make the ounce (Oz) to be the unit, you
can execute the g/Oz conversion. The unit of the
displayed unbalance value is gram（g）. The way to
realize the unit conversion from gram to ounce is to
press
6.4.5 When press the start key，the wheel balancer
starts to run. A few seconds later, the machine
automatically stops. The machine can also start by
lowering down the protective hood which can be set by
the program.
to input the Br
6.4.6 DISPLAY UNBALANCE VALUE
When the spin ends, the display will display the inner
rim. Use your hand to pull the wheel. When all the
positioning lamps light inside and outside light, the
weight adding position will be indicated.
6.4.7Rotate the wheel, when the left side positioning
lamp all light, at this moment, the highest position is the
inner unbalance position and when the right side
positioning lamp all light, at this moment, the highest
position is the outer unbalance position.
6.4.8 Add the corresponding weight at the unbalance
point and start test again until the balance of the tire.
Attention：
1.
wheel to help it start rotation, especially to the relative
bigger tire, to prolong the working life of the motor.
2.
Check if the balance methods meet the configuration of
the rim and select the balancer most easily to balance.
3.
4.
attention to handle it with gentle and avoid knocking the
main shaft.
5.
the weight on the rim without too much force. Do not
knock the main shaft hardly to avoid damaging the
sensor. The position to add the Weight should be free
from the grease and should be dry.

6.5 RESIDUAL UNBALANCE VALUE DISPLAY

The minimum value of the standard weight is 5g so if
the weight you use is less than 5 g, the wheel balancer
will not display the value and only displays the state of
"00". When you need to display the residual unbalance
10
and outer
When start the machine, use hand to pull the
Check if there are any mistakes on the dimension.
Check if the quick lock nut tight or not.
When the balance ends, remove the tire. Pay
When clipping the weight. Use the hammer to clip
unbalance value of the