Running Bist Tests - Xilinx KC705 Getting Started

Chapter 1: Getting Started with the Kintex-7 FPGA KC705 Embedded Kit
10. Repeat

Running BIST tests

11. A Web server-based BIST demonstration can also be run on the same hardware to test
12. Reload the Web page with the same URL (192.168.1.10). The Web page should appear
X-Ref Target - Figure 1-7
Figure 1-7: BIST Demonstration Web Page with DDR3 test results
13. The left side of the Web page has different options for selecting the type of test to run
The Video and BIST demonstrations using the KC705 board are complete. Because a fully
configured MicroBlaze processor subsystem has been provided, the user can start
developing embedded applications. Because an FPGA is being used, the processor
subsystem can also be fully customized. To do this, the ISE Design Suite and the
USB-UART driver must be installed on the computer (see
Licensing of ISE Design
14
step 7, step 8, and
changing the selections mentioned in
different peripherals. Enter these commands at the XMD prompt to run the BIST
demonstration:
XMD% stop
XMD% dow Bist.elf
XMD% con
as shown in Figure 1-7.
on the hardware. For running the test, select any option from the list and press the Go
Target button. The right side of the Web page has a messaging section that prints the
results of the tests.
Suite).
www.xilinx.com
step 9 to explore different VIDEO DEMO TESTS options by
step 7.
UG913_c1_07_051612
Appendix C, Installation and
KC705 Getting Started Guide
UG913 (v1.0.1) May 31, 2012