L2Ogre With Ttg Pdg Profile With 802.1X Authentication - Ruckus Wireless SmartCell Gateway 200 Reference Manual

Tunneling interface for smartzone 3.4.1

Hide thumbs Also See for SmartCell Gateway 200:

Table of Contents

Core Network Protocols

Figure 2. L2oGRE control and data traffic flow.

NOTE:

For information on how to configure L2oGRE, refer to the SmartCell

Gateway 200 Administrator Guide (PDF) or the SmartCell Gateway 200 Online Help,

which is accessible from the SCG Web interface.

L2oGRE with TTG PDG Profile with 802.1x

Authentication

This network protocol supports authentication of UE tunnel traffic from 3rd party

APs using 802.1X, via L2oGRE tunnels. 3rd party AP UE's using 802.1X authenti-

cation is already supported with QinQ access and LBO core forwarding by config-

uring the TTG+PDG profile.

The UE authentication is similar to QinQ and LBO expects that the UE packet is

seen at the data plane from an L2oGRE tunnel. This means that the L2oGRE and

LBO path is already supported for the parameter auth_type.

SmartCell Gateway 200 Tunneling Interface Reference Guide for SmartZone 3.4.1, 800-71380-001 Rev A

Table of Contents

Need help?

Do you have a question about the SmartCell Gateway 200 and is the answer not in the manual?