Screen Creation Procedure - Omron NT631 Series Reference Manual

Screen Creation Procedure

3-1

Screen Creation Procedure

Creating a New Screen
Tool Setting (for PT Type)
Set the PT model as follows:
NT31: Set NT31-V2.
NT31C: Set NT31C-V2.
NT631: Set NT631-V2.
NT631C: Set NT631C-V2.
System Setting (Memory Switch Setting)
Set the memory switches that determine the
basic operation of the PT.
The numeral/character string/bit memory table
settings should also be made at this stage.
Setting for PT Status Control/Notify Area
Allocate the PT status control area and PT
status notify area, necessary for the direct
connection function, to words at the host.
For details, refer to 2-2 Areas for
Control/Notification (page 46).
278
Downloaded from Elcodis.com electronic components distributor
Follow the procedure shown below to create screens for the NT31/NT31C and
NT631/NT631C.
The following gives the procedure assuming that the setting for the PT has been
completed. The operating procedure for a Support Tool is not given here. For the
operating procedure for the Support Tool, refer to the NT-series Support Tool
Ver. 4.1 for Windows Operation Manual .
Correcting an Existing File
File Designation
Designate a work file.
NT-series Support Tool
Section
Importing DOS Version Data
File Designation
Designate the work file to be data converted.
NT-series Support Tool
3-1