Direct Tuning; Automatic Tuning - Sony STR-DB930 Operating Instructions Manual

Direct Tuning

Use the supplied remote to perform the following
operations.
For details on the buttons used in this section, see the
operating instructions for the supplied remote.
1
Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3
Press DIRECT (or D. TUNING).
4
Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz
b b
1 0
Example 2: AM 1350 kHz
1 b 3 b
If you cannot tune in a station and the
entered numbers flash
Make sure you've entered the right frequency. If not,
repeat Steps 3 and 4.
If the entered numbers still flash, the frequency is not
used in your area.
5
If you've tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
6
Repeat Steps 2 to 5 to receive another station.
z
If you try to enter a frequency that is too precise for the
tuning scale
The entered value is automatically rounded up or down.
Tuning scale is:
FM: 50 kHz
AM: 9 kHz
b b
2 5 0
5 b 0

Automatic Tuning

For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 42.
1
Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3
Press TUNING (PTY SELECT) + or TUNING (PTY
SELECT) –.
Press the + button to scan from low to high; press the –
button to scan from high to low.
When the receiver reaches either end of the
band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is
received.
4
To continue scanning, press TUNING (PTY SELECT) +
or TUNING (PTY SELECT) – again.
43 GB