Samson 3430 Operating Instructions Manual page 23

Mounting parts for bulb sensor Ø 12 mm, length
425 mm
Clamping flange
For wall mounting, e.g. pressureless containers or
ducts
Order no. 1090-9547
Mount flange to wall using two screws and attach
temperature sensor with two other screws in the
flange.
Screw gland (PN 10)
G ½ Order no. 1080-4881
G ¾ Order no. 1080-4882
Fill screw fitting with sealant. Insert sensor with screw
gland and coupling nut.
Tighten coupling nut.
Screw gland (PN 40) with clamping nut
G ½ Order no. 1080-4884
G ¾ Order no. 1080-4885
Install as described above. Tighten clamping nut
instead of coupling nut.
Thermowell with thread (PN 63)
G ½ Order no. 1080-4888
G ¾ Order no. 1080-4889
Use a thermowell when the nominal pressure is
exceeded, when corrosive media are involved or
when the plant is to continue to run while the sensor is
being replaced.
Insert sensor right to the bottom of the thermowell.
Tighten coupling nut.
Thermowell for welding (PN 63)
Order no. 1080-4890
Thermowell with flange
Order no. 1080-4891 (PN 40)
1080-4892 (PN 100)
Note: All wetted parts of the screw gland and thermo-
wells are made of stainless steel 1.4571.
Fig. 13 · Mounting parts for bulb sensor
32
8
G
SW 32
G
SW 32 G¾
385
375
335 40
Installation
Ø50
G¾
1 36
12
30
G SW 32
SW 32
SW 32
23
EB 7030 EN