Setup; Installing The Dump Handle; Installing The Tow Pole - Toro MMX-655H-S Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1

Installing the Dump Handle

Parts needed for this procedure:
1 Dump handle
2 Carriage bolt
2 Nut
Procedure
1. Cut the cable ties to remove the dump handle
from the underside of the grate.
2. Install the dump handle to the side of the drum
using 2 carriage bolts (installed on the inside of
the drum) and nuts as shown in
Description
Dump handle
Carriage bolt
Nut
Tow pole kit (sold separately)
Safety chain (included with the tow pole
kit)
Connecting link (included with the tow
pole kit)
No parts required
Figure 3.
Qty.
1
2 Install the dump handle.
2
Install the tow pole (side-dump models
1
only).
1
Install the safety chain.
2
–
Adjusting the mixing paddles.
9
Use
Figure 3
g028569