Table of Contents
Advertisement
9.
Rinse and dry the foam element thoroughly.
10.
Dip the foam element in clean engine oil, then
squeeze out the excess oil.
Note:
Excess oil in the foam element restricts
the air flow through the element and may reach
the paper filter and clog it.
11.
Wipe dirt from the base and the cover with a
moist rag.
Note:
Be careful to prevent dirt and debris from
entering the air duct leading to the carburetor.
12.
Install the air-cleaner elements and ensure that
they are properly positioned.
13.
Securely install the cover with the nut.
Servicing the Engine Oil
Engine-Oil Specifications
Toro Premium Engine Oil is available from your
Authorized Toro Dealer.
Important:
Use 4-cycle engine oil that meets or
exceeds the requirements for API service category
SJ, SL, SM, or higher.
Model(s)
60213 and 60213C
60216, 60216C, 60220, and
60220C
Important:
If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine. This type of damage is not
covered by the warranty.
Note:
Use SAE 10W-30 for general use. You can
use the other viscosities shown in the chart when
the average temperature in your area is within the
indicated range
(Figure
Figure 39
Crankcase Capacity
0.58 L (19.6 oz)
1.1 L (1.2 US qt)
39).
Checking the Engine-Oil Level
Service Interval: Before each use or daily
1.
Park the machine on a level surface and shut
off the engine.
2.
Allow the engine to cool.
3.
Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page
4.
Clean around the dipstick.
5.
Check the oil level as shown in
Changing the Engine Oil
Service Interval: After the first 25 hours
g013375
Every 100 hours
31
Figure
40.
Figure 40
28).
g035136
Advertisement
Table of Contents
