Table of Contents
Advertisement
Note:
Do not remove the forward hinge bracket.
Figure 50
11.
Remove the engine and engine deck from the
machine
(Figure
50).
Installing the Engine
1.
Align the engine and engine deck to the rear
frame of the machine.
Note:
The drive pulley on the engine must align
forward.
2.
Align the pivot on the engine deck with the
forward hinge bracket
3.
Slide the engine deck forward and the pivot into
the forward hinge bracket
4.
Align the rear hinge bracket with the pivot on the
engine-deck hinge
5.
Lift up on the rear edge of the engine deck and
slip the hinge bracket onto the pivot.
6.
Secure the rear bracket to the frame of the
machine using the bolt and nut
g020121
removed in step
(page
35).
7.
Using a spring-removal tool (Toro Part No.
92-5771), install the tension spring to the anchor
bracket on the engine deck
8.
Install the belts and belt guide; refer to
the Belts (page
9.
Adjust the belt guide; refer to
Guide (page
10.
Install the divider plate; refer to
Divider Plate (page
36
(Figure
50).
(Figure
50).
(Figure
50).
(Figure
8
of
Removing the Engine
(Figure
43).
Adjusting the Belt
43).
Installing the
28).
49)
48).
Installing
Advertisement
Table of Contents
