Toro MMX-655H-S Operator's Manual page 6

Fuel Safety
•
Use extreme care in handling fuel. It is flammable
and its vapors are explosive.
•
Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
•
Use only an approved fuel container.
•
Do not remove the fuel cap or fill the fuel tank
while the engine is running or hot.
•
Do not add or drain fuel in an enclosed space.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
•
If you spill fuel, do not attempt to start the engine;
avoid creating any source of ignition until the fuel
vapors have dissipated.
Operation
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not run an engine in an enclosed or poorly
ventilated area.
•
Operate the machine only in good lighting
conditions.
•
Before starting the machine, ensure that there are
no people or obstacles near or under the machine.
•
Shut off the engine before leaving the machine for
any reason.
Never leave a running machine unattended.
Always shut off the engine and verify that all
moving parts have stopped.
•
Chock the tires of the machine or keep it attached
to the towing vehicle when it is not in use.
•
Keep your hands away from any moving parts.
Keep your feet away from the tires and the front
post.
•
Do not operate the machine under the influence
of alcohol or drugs.
•
Do not place your hands or any solid object into
the drum when the machine is in operation.
•
Do not touch parts that may be hot from operation.
Allow them to cool before attempting to maintain,
adjust, or service the machine.
•
Never move the machine while the engine is
running.
•
Keep the cowl closed and latched during operation.
•
Ensure that all the guards and shields are securely
in place before operating the machine.
•
If the mixing paddles strike an object or if the
machine starts making an unusual noise or
vibration, shut off the engine, wait for all moving
parts to stop, and empty the drum. Inspect for
clogging or damage. Clean, repair, and/or replace
any damaged parts.
•
Do not change the engine governor setting or
overspeed the engine.
•
Do not operate the machine when there is the risk
of lightning.
Maintenance and Storage
•
Before performing maintenance, do the following:
– Park the machine on a level surface.
– Shut off the engine and wait for all movement
to stop before adjusting, cleaning, or repairing
the machine.
– Let the engine cool before performing
maintenance or storing the machine.
– Disengage all power and operation controls.
•
Never lubricate, service, repair, or adjust the
machine with the engine running.
•
Keep equipment materials clear from the muffler
and engine to prevent fires. Clean up oil or fuel
spills.
•
Never allow untrained personnel to service the
machine.
•
Keep your hands, feet, and clothing away from
moving parts. If possible, do not make adjustments
with the engine running.
•
Keep all parts in good working condition and all
fasteners tightened. Replace all worn or damaged
decals.
•
Remove any buildup of grease, oil, or debris from
the machine.
•
Stop and inspect the machine if an object enters
the drum or causes another obstruction. Make all
necessary repairs before starting the machine.
•
Do not tamper with safety devices.
•
Chock the tires when storing the machine.
•
Keep all fasteners and hose clamps securely
tightened and all equipment in good condition.
•
Use only genuine Toro replacement parts.
6