Toro MMX-655H-S Operator's Manual page 14

Choke Lever
Use the choke lever (Figure
Before pulling the recoil-start handle, move the choke
lever to the C position. Once the engine is
LOSED
running, move the choke lever to the O
Do not use the choke if the engine is already warmed
up or if the air temperature is high.
Throttle Lever
The throttle lever (Figure
of the engine. It is located next to the choke lever. It
sets the engine speed and therefore can increase and
decrease the rotation speed of the mixing paddles.
For best performance, set this control to the F
position when mixing material.
Engine On/Off Switch
The On/Off switch is located on the front of the engine.
•
Rotate it to the O
N
engine.
•
Rotate it to the O
FF
1. O position
FF
Recoil-Start Handle
To start the engine, pull the recoil-start handle
10) quickly to turn the engine over. The engine
controls described above must all be set correctly for
the engine to start.
Oil-Level Switch
The oil-level switch is located inside the engine, and it
does not allow the engine to run in the event the oil
level is below the safe operating limit.
11) to start a cold engine.
position.
PEN
11) controls the speed (rpm)
position to start and run the
position to shut off the engine.
Figure 12
2. O position
N
AST
g021103
(Figure
14