Setup; Installing The Dump Handle; Installing The Tow Pole - Toro MM Series Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1

Installing the Dump Handle

Parts needed for this procedure:
1 Dump handle
2 Bolt
2 Nut
Installing the Dump Handle to the Drum
1. Cut the cable ties to remove the dump handle from
the underside of the grate.
2. Position the dump handle so that the bolt holes align
with the bolt holes in the drum (Figure 3, Figure 4,
or Figure 5).
Models 68013, 68016, 68020
Description
Dump handle
Bolt
Nut
Tow pole kit (sold separately)
Safety chain
Connecting link
G022169
Figure 3
Qty.
1
2 Install the dump handle.
2
1 Install the tow pole.
1
Install the safety chain.
2
Models 68014, 68017, 68021
3. Insert the 2 bolts through the bolt holes in the dump
handle and the drum (Figure 3, Figure 4, or Figure 5).
4. Install a nut onto each bolt, and tighten them by hand
to prevent cross-threading.
5. Tighten the nuts with a wrench while using another
wrench to keep the bolts from spinning.
8
Use
G022150
Figure 4
G022149
Figure 5
Model 68024