Setup; Installing The Dump Handle; Installing The Tow Pole - Toro MMXD-958H-S Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1

Installing the Dump Handle

Parts needed for this procedure:
1 Dump handle
2 Bolt
2 Nut
Installing the Dump Handle to the Drum
1. Cut the cable ties to remove the dump handle from
the underside of the grate.
2. Position the dump handle so that the bolt holes align
with the bolt holes in the drum
3. Insert the 2 bolts through the bolt holes in the dump
handle and the drum
4. Install a nut onto each bolt, and tighten them by hand
to prevent cross-threading.
Description
Dump handle
Bolt
Nut
Tow pole kit (sold separately)
Safety chain (sold with the optional tow
pole kit)
Connecting link (sold with the optional
tow pole kit)
(Figure 3).
G021589
Figure 3
(Figure 3).
Qty.
1
2 Install the dump handle.
2
1 Install the tow pole.
1
Install the safety chain.
2
5. Tighten the nuts with a wrench while using another
wrench to keep the bolts from spinning.
2

Installing the Tow Pole

Parts needed for this procedure:
1 Tow pole kit (sold separately)
Installing the Tow Pole to the Machine
Note: The tow pole is purchased separately and includes the
nut and bolt needed for installation.
The machine has the following tow pole options:
Hitch Type
50 mm (2 inch) ball—stamped
50 mm (2 inch) ball—forged
Pintle
1. Remove the bolt and nut from the tow pole
7
Use
Length
127 cm (50 inches)
127 cm (50 inches)
127 cm (50 inches)
(Figure 4).