Dmx Addressing - ADJ Par Z Move RGBW User Instructions

Hide thumbs Also See for Par Z Move RGBW:

Table of Contents

Par Z Move RGBW

All fixtures should be given a DMX starting address when using a DMX controller, so the correct fixture

responds to the correct control signal. This digital starting address is the channel number from which

the fixture starts to "listen" to the digital control signal sent out from the DMX controller. The assignment

of this starting DMX address is achieved by setting the correct DMX address on the digital control

display on the fixture.

You can set the same starting address for all fixtures or a group of fixtures, or set different addresses

for each individual fixture. Setting all fixtures to the same DMX address will cause all fixtures to react

in the same way, in other words, changing the settings of one channel will affect all the fixtures

simultaneously.

If you set each fixture to a different DMX address, each unit will start to "listen" to the channel number

you have set, based on the quantity of DMX channels of each fixture. That means changing the settings

of one channel will only affect the selected fixture.

In the case of the Par Z Move RGBW, when in 13 channel mode you should set the starting DMX address

of the first unit to 1, the second unit to 14 (13 + 1), the third unit to 27 (14 + 13), and so on. (See the

chart below for more details.)

Channel Mode

13 Channels

15 Channels

16 Channels

ADJ Products, LLC - www.adj.com - Par Z Move RGBW User Manual Page 11

Unit 1

Unit 2

Address

DMX Addressing

Unit 3

Unit 4

Address

Table of Contents