Cautions Regarding On Connecting The Anchor Bolt; Cautions Regarding On Connecting The Pipe; Cautions Regarding On Anti-Vibration Frame Installation - Samsung DVM S Series Installation Manual

Cautions regarding on connecting the anchor bolt

CAUTION
Tighten the rubber washer to prevent the bolt connection part of the outdoor unit from corroding.
Rubber washer
Anchor specification
Diameter of
Size
drill bit (a)
Ø 10 14 mm
❇ Use the anchor bolts and nuts that is zinc plated or made of STS material. Regular
anchor bolts or nuts may get damaged by corrosion.

Cautions regarding on connecting the pipe

If you install the outdoor unit on the rooftop, check the strength and make sure to waterproof the rooftop.
Construct draining pit around the base construction and pay attention to the drainage around the outdoor
unit. (Condensation or defrost water may form during outdoor unit operation.)
If there's any possibility of small animals from entering the pipe outlet, block the outlet as shown in the
illustration.

Cautions regarding on anti-vibration frame installation

During installation, make sure there is no gap between the base ground and the supporting structures such as
anti-vibration frame or H beam.
Base ground must be constructed strongly to support the bottom part of the anti-vibration mount.
After installing the anti-vibration frame, untighten the fixing part on the top and bottom part of the frame.
Anchor length Sleeve length
(b) (c)
75 mm 40 mm
Block the part. (When withdrawing the pipe from
the front side)
Liquid side pipe
Gas side pipe
Fastening
Insert depth
torque
50 mm 30 N·m
M10
a
27