Insulate The Distribution Header; Insulating The Branch Joint - Samsung DVM S Series Installation Manual

Pipe insulation

Insulate the distribution header

Fix the distribution header with a cable tie and cover the connected part.
Insulate the distribution header and the welded part and wrap the connected part with an
adhesive insulation tape to prevent dew formation.
Adhesive insulation tape
Insulate the refrigerant
Insulate the
pipe
distribution
header
Fix the distribution header with a hanger after insulating it.

Insulating the branch joint

Tightly attach the insulator, provided with the branch joint, to the separately purchased insulator. Wrap the connected
part with an insulator (separately purchased item) that has thickness of at least 10mm.
Use an insulator that resist heat up to 120°C. Wrap the branch joint with an insulation that has thickness of at least 10mm.
Pipe insulator
(Separately
purchased item)
Fix securely without
any gap.
150mm
Branch
joint
Thickness of the insulator (Separately purchased
item) should be thicker than 10mm.
84
Provided
Insulator
Fix securely without any gap.
Pipe insulator
(Separately
purchased item)
Insulate after welding a stopper
Adhesive insulation tape
Insulation tape (Separately purchased item)
Pipe
Pipe insulator (Separately purchased item)
❇ Attach the adhesive insulation
tape to the pipe, as shown in the
picture, after insulating the pipe.
Insulation