Insulating The Pipe Located Inside Of The Outdoor Unit; Charging Refrigerant (For The Turkish Market Only) - Samsung DVM S Series Installation Manual

Insulating the pipe located inside of the outdoor unit

With a pipe insulator, insulate the pipe up to whole service valve located inside of the outdoor unit.
Seal the gap between the outdoor unit pipe and the insulator. Rainwater and dewdrops may soak through the gap
between the pipe and the insulation of the outdoor unit installed on the outside.
Separate the cover of the pipe and close it after insulation work. Only remove a knock-out hole cover where the pipe will
be installed. If the knock-out hole is open unnecessarily, it must be closed. If not, small animals such as squirrels and rats
may get into the unit through the hole and the unit may be damaged.
H/P
H/R

Charging refrigerant (for the turkish market only)

The R410A refrigerant is blended refrigerant. Add only liquid refrigerant.
Measure the quantity of the refrigerant according to the length of the liquid side pipe. Add quantity of the refrigerant
using a scale.
Important information regulation regarding the refrigerant used
This product contains fluorinated greenhouse gases. Do not vent gases into the atmosphere.
• Inform user if system contains 5 tCO
for leakage at least once every 12 months, according to regulation n°517/2014. This activity has to be covered
CAUTION
by qualified personnel only. In case situation above (5 tCO
which has responsibility for final check) has to provide a maintenance book, with all the information recorded
according to REGULATION (EU) No 517/2014 OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 16 April
2014 on fluorinated greenhouse gases.
e or more of fluorinated greenhouse gases. In this case, it has to be checked
2
e or more of R-410A), installer (or recognized person
2
85